Smart 44's Wi-Fi & OCPP server configuration

AP Mode function lets you to directly connect to the configuration page of the charger to setup the Wi-Fi network SSID and Password & also set the OCPP server that the charger needs to connect to.

1. Network Connection

Please follow the steps below to complete the network connection.

Step 1: Wi-Fi Connection

(1) Switch your phone to airplane mode

(2) Make sure Wi-Fi is enabled

(3) Select charger point Wi-Fi name. The name of the Wi-Fi SSID begins with”AC022.....”, it is the same as the charger’s serial number.

(4) Enter Wi-Fi Default password to connect: admin123

Step 2: Login

(5) Open a web browser

(6) Enter the IP Address in the address bar as: 192.168.4.1

(7) Enter 4-digit network password (PIN Number)

The network pin can be found on the cover of the charge point. Please keep the PIN sticker on a safe place to access it later.

Note: Please make sure the Wi-Fi SSID which you connected is correct if you can not enter the login interface via the default IP address.

Step 3: Wi-Fi Setup

(8) Select “Charger Point Setup”

(9) Wi-Fi Setup

You can select the Wi-Fi SSID name that you want to connect. Select “Other” and enter Wi-Fi SSID and Password manually if the Wi-Fi network is not showing in the list. (Make sure to enter the Wi-Fi SSID carefully while entering it manually)

Note: After Wi-Fi setup, you need repeat step (3) to login again.

(10) Verifying Network Connectivity

After re-login, please make sure the Wi-Fi strength is Excellent, Server communication is “Connected”, and the network status is Online.

If the Wi-Fi strength is poor, please try to change the Wi-Fi network or arrange a range extender to enhance the network strength.

If the server communication is “Disconnected” or the network status shows Offline, please try to reset network setting, and then repeat Step 2 and Step 3.

2. Reset Network Setting

If you wish to rest all the settings that you have performed, follow the below steps. Please proceed with caution as the information will be removed.

Please click A to reset network settings, and click B to confirm.

After you reset the network setting, the network configuration information is the same as D shows.