Installing CITA Smart 44 Gen 3

Warning Electric Shock

INSTALLATION OF ANY ELECTRICAL DEVICE SHOULD BE CARRIED OUT BY A SUITABLY QUALIFIED AND COMPETENT PERSON.

A qualified person has the skills and knowledge related to the construction, installation, & operation of electrical devices and has received safety training to recognize and avoid the hazards involved.

Keep in mind

Before installing the CITA Smart 44 (Gen 3), make sure that the power line you’re using is switched off on your service panel.

Make sure that the power line to CITA Smart 44 (Gen 3) is installed on a dedicated circuit breaker (MCB) on your service panel.

The installation must incorporate an adequate residual current device (RCD).

The MCB must be in line with the capacity of the charging cable (22 kW).

If the amperage rating of the charging cable is different than that of the (MCB), the installer/user must change the station settings in the mobile app and/or web platform for station management as provided by the operator or service provider for this product.

THIS IS A GLOBAL PRODUCT, AND LOCAL WIRING REGULATIONS AND SAFETY PRECAUTIONS WITHIN THE COUNTRY OF INSTALLATION SHOULD BE ADHERED TO AT ALL TIMES.

The CITA Smart 44 (Gen 3) requires Wi-Fi/Ethernet/LTE to bring it online. Before installation, it is advised to ensure that you have one of the communications methods.

Tools Needed For The Installation

Preparing for Installation

Cables & Materials

Installation Process

1) Installation Notice

a) Electrical products should be installed, operated, serviced, and maintained only by qualified personnel. No responsibility is assumed by the manufacturer for any consequences arising out of the installation of this product.

b) A qualified person who has skills and knowledge related to the construction, installation & operation of electrical products & who has received safety training to recognize and avoid the hazards involved.

c) All applicable local, regional, and national regulations must be respected when installing, repairing, & maintaining this product

2) Layout Cables

Select the standing positions of the charger on the ground. Lay network cables & power supply cables under the ground. Cables come out of the ground from the center of the standing position with about 100cm length above the ground.

3) Fix Charger

Locate the footprint of the charger on the ground in a standing position. Drill the four screw holes as indicated below on the ground for the fixation of the charger. Place the charger on the standing position & fix the four screws

Note: Make sure that the charger is installed on a concrete base or platform above the ground level